Innovation Technology SF6 User Manual Page 9
- Page / 17
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
Page 8
8.1 USER SETUP:
This paragraph describes the parameters that determine the behaviour of the instrument.
The first step is always.
Activating the Menu System. In normal operation, the instrument can be taken to
programming mode by simply touching the touch-screen. From the main menus, items
can be selected.
Touching the screen will display the following menu structure:
Set volume / Contrast
Open Operator Level
Open Supervisor Level
Open Tech Level
Exit
In the following, it is presumed that this menu is displayed on the screen.
Passwords and Numeric Values must be entered as required. Numeric or alphanumeric
keypads appear as required. Just touch the appropriate buttons, using +/- to delete the
last digit and RETURN to confirm the entry.
In some cases, the present value of a parameter will already be entered. You may then
confirm or delete and re-enter.
8.2 Set volume / Contrast
Using the three slider type controls on this screen, select contrast for best visibility. Be
careful with the contrast, if you bring the slider to its extreme positions it is possible that
the screen appears blank. If this happens, and your finger is still on the screen, then run
it straight upwards until the screen contents reappears.
The - and + buttons are for fine adjusting the contrast. These provide better resolution
than the sliders. Every 5 presses advance the slider one step.
9.0 Open Operator Level
This menu displays to following:
9.1 Operator ID
If the operator's name is required on the data printout, the name can be entered here.
If the mode "Force Operator ID by Name" is active, this screen will automatically appear
after power up. If nothing is entered, normal operation is possible but data printout is not
possible.
- INSTRUCTION MANUAL 1
- GAS-CHECK SF 1
- 3.0 GENERAL: 3
- 3.1 SAFETY: 3
- 4.0 SYSTEM PROPERTIES: 4
- Introduction: 4
- 4.1 CONSOLE CONTROLS: 4
- 6.0 HANDGUN BUTTONS: 6
- 7.0 GETTING STARTED: 7
- 7.1 MEASURING OPERATION: 7
- 7.3 LOW FLOW ERROR: 8
- 7.4 FLARE STALL: 8
- 7.5 LOW BATTERY VOLTAGE: 8
- 7.5 SWITCHING OFF: 8
- 8.1 USER SETUP: 9
- 8.2 Set volume / Contrast 9
- 9.0 Open Operator Level 9
- 9.1 Operator ID 9
- Open tech level 11
- 11.0 Calibration 12
- 11.1 Set clock 12
- 12.0 User set-up 13
- 12.3 Display units 13
- 14.1 RS232 Protocol 14
- 13.2 Standby mode 14
- 14.0 Standby delay 14
Sony MHC-DX30 manuales
Manuales del propietario y guías del usuario para Reproductores de cd Sony MHC-DX30.
Ofrecemos 2 manuales en pdf Sony MHC-DX30 para descargar gratis por tipos de documentos: Manual de usuario
Comments to this Manuals